Walk-In Tub Care

New-2014-StepinTubs-4

Care and Maintenance of Your Walk In Tub

Walk In Tub Care

  • When you clean your tub, DO NOT use wire brushes, steel wool or other abrasives.
  • Epsom Salts will not harm your tub, when used in moderation.
  • The electrical components of your tub require no maintenance.
  • Oils or oil-based bath additives are not recommended.

 

Regular Cleaning

When you are finished using your tub, be sure to rinse all surfaces with the shower wand with the water set to WARM. Once a week, wash all of your tub’s surfaces using a mild solution of acrylic-friendly cleaner. Each month, purge and clean the tub’s entire system. If body oils, bath oils, soap residue, etc. begin to build up on your tub’s surfaces, you can remove them with automatic dishwashing soap and a cup of bleach. Using warm water, fill your tub to a level just above the highest whirlpool jet. Mix a cup of bleach and a spoonful of automatic dishwashing soap into the water. Turn your system on, let it run for 15 minutes, and then drain the water. Now, refill the tub with warm water only. Let the system run for an additional 15 minutes. This will rinse out the plumbing. Drain the tub, use the shower wand to rinse off the surface, and then wipe with a soft clean cloth.